ASO MILL Blog

<< Cabinet doors DIYで扉作成
2021-02-02
Making a loft ladder ロフト梯子DIY >>
2021-02-04

Sink cabinet #1 洗面台DIY作成

2021-02-03 by David

この家には洗面台3つあります。1階と2階のトイレとお風呂の前。今回、一番小さい洗面台をDIYで作ります。

 

This house has bathroom 3 sinks that could do with replacing, so today I'll do the smallest of those - the 1st floor toilet.



▲ 1階のトイレは階段の下ですから狭い所でキャビネットを作ります。古いキャビネットは写真のようでした。

 

It's a pretty small space in here under the stairs, but the old metal sink is too small, too low and too damn ugly!





▲ アマゾンから買った「Kindness 洗面用水栓」(4,099円)です。混合水栓ですが、トイレの水管にはお湯はありませんので、一本のパイプでつなぎます。

 

Rather than an expensive made-in-Japan tap, I bought this simple white and chrome mixer tap on Amazon Japan for $40. The downstairs toilet doesn't actually have a hot water connection, so I'll only be using one of the two pipes that came with the fitting.





▲ シンクはまたイケアで買いました。「GUTVIKEN」(9,000円)は一番小さいタイプだと思います。埋め込みタイプではなく、キャビネットの上に載せます。

 

Want to guess where the sink came from? Yes, of course, it's from Ikea again! This is their smallest size sink, at $90, and sits on top of the cabinet rather than set into it.





▲ 古いキャビネットを外して、阿蘇市の未来館リサイクルセンターで捨てました。床タイルの線で10センチのベースを厚み18mm化粧板で作りました。

 

After ripping the old metal cabinet out, I made this simple 10cm tall base from offcuts left over from the kitchen build.





▲ 縦とカウンターを載せるフレームを作りました。簡単でしょう?!

 

Then one more 18mm white wood veneer board for the bottom and some more offcuts for the frame. Easy, yes?

 




▲ カウンターはキッチンと同じタイプのイケア「KARLBY」を使いました。一番長い259cmのカウンター(27,000円)を買って、3つにカットしました。3か所の洗面台で使うつもりですので、1つの洗面台には9000円になります。

 

カウンターに穴を開けて、シリコンでシンクの下にコーキングしました。

 

The counter is from a long 259cm walnut counter from Ikea. I bought a long counter for $270, with plans to cut it into 3 parts for each of the 3 washrooms I was planning to use it in.

 

Once a small hole was cut in the centre of the counter, the sink was placed on top and sealed with silicon caulking.

 

 

 

▲ 最後にイケアの「BESTA」(2個で1000円)のヒンジと化粧板で扉を作りました

 

シンプルでおしゃれな洗面台は合計33,000円でできました!店で買うと同じぐらいの値段かもしれないが好きなスタイルの作成が楽しかった。

 

The last job was to make 2 cabinet doors and fit the Ikea BESTA hinges, as I did for the kitchen cabinet doors.

 

In total, the cabinet cost $330, but a large part of that was the fairly expensive countertop and sink. It's probably about comparable in cost to a shop-bought cabinet, to be honest. However, I think it was worth it to have a wall-to-wall fitted cabinet in exactly the style I wanted!

 


Tags: toilet  トイレ 


0 Comments :




Write a comment :
Name
Comments
Enter Code



<< Cabinet doors DIYで扉作成
2021-02-02
Making a loft ladder ロフト梯子DIY >>
2021-02-04


We are OPEN today!


〒869-2226 熊本県阿蘇市乙姫2070-48
Aso City, Otohime 2070-48
Open from 10:00~17:00*
Closed on Sundays & Mondays
(* if the door's closed, we might have popped out to walk the dog... back soon!)